EM anomaly: a “pointer” for hydrocarbonsEM anomaly at Lower Cretaceous level in the Pointer/setter well (Figure EMGS)

EM anomaly: a “pointer” for hydrocarbons

According to EMGS the Pointer/Setter well in the Hammerfest Basin will find hydrocarbons.

Lundin is drilling well 7121/1-2S on the Pointer/Setter prospect in the Barents Sea (read also “Lundin tests Lower Cretaceous in Hammerfest Basin”). The target of the well is a stratigraphic trap of Lower Cretaceous sands sourced from the Loppa High.

Pål Gabrielsen from EMGS says: “The well is drilling through a strong CSEM resistive anomaly located at the depth interval of interest. High resistivity can be caused by lithology changes such as cemented sands, carbonates and mature source rock. However, the most interesting cause of resistive anomalies mapped by CSEM data is large hydrocarbon accumulations. Knowing that there are several seismic analogues to this play in the Hammerfest basin, but only a few of them are associated with high resistive anomalies from the CSEM data, makes us very excited about this well.”

Pointer-Setter Well is drilling through a strong CSEM resistive anomaly (Figure EMGS)


The CSEM technology has been around since the 1990’s but the major part of the industry has remained somewhat sceptical about its impact. According to Westwood the CSEM technology has proven a relatively reliable tool to polarise the risk of presence of hydrocarbons. The commercial success rate of prospects associated with EM anomalies has, however, been poor. (Advances in Exploration Technology and Geosciences).

The Barents Sea is the place where CSEM data have shown its potential especially in shallow reservoirs such as at Wisting but also in the Johan Castberg area. One of the discoveries supported by CSEM data was Kayak (7219/9-2), a similar Lower Cretaceous stratigraphic trap in the Bjørnøyrenna Fault Complex. Statoil found 25-50mmbbl of oil in the Kolje formation in Kayak.

“Mitigating seal risk of a stratigraphic trap based on seismic data is difficult. Using CSEM data to solve the puzzle should help.” Adds Gabrielsen.

In a couple of weeks, we will find out if it worked for Pointer/Setter. The drilling operations started on the 6th of January and will take approximately 60 days for the main well and 120 days including side-track and formation tests.